Material Modeling and Calibration

Material Modeling and Calibration

Published on March 23, 2017
An Integral Part of Finite Element Analysis Material modeling is an integral part of Finite Ele...

Particle Methods in Abaqus: DEM vs. SPH

Particle Methods in Abaqus: DEM vs. SPH

Published on March 21, 2017
This eSeminar will present an overview of the two particle methods in Abaqus – Discrete Element...

Enhanced Abaqus Welding Interface

Enhanced Abaqus Welding Interface

Published on March 16, 2017
Abaqus has always been a software of choice for modeling welding in various industries. This eS...

Accelerate Automotive Suspension Development with Collaboration

Accelerate Automotive Suspension Development with Collaboration

Published on March 14, 2017
If you look at Automotive Suspension Design and Development, the challenges are obvious. Two ma...

Efficient Cooling Channel Design of a Turbine Rotor Blade

Efficient Cooling Channel Design of a Turbine Rotor Blade

Published on March 9, 2017
In order to permit high fuel efficiency and power output, jet engines needs to deal with high r...

End-to-end Solution for Mold Tooling Analysis

End-to-end Solution for Mold Tooling Analysis

Published on March 7, 2017
Performance Based Plastic Part and Mold Design Creating a new plastic product and getting it to...

Set Your Product in Motion and Validate Your Ideas

Set Your Product in Motion and Validate Your Ideas

Published on March 2, 2017
In Mechanical Engineering, there are many examples of products in motion: car suspensions in th...

Virginia Tech Formula SAE Motorsport Team uses Abaqus to Cross Finish Line

Virginia Tech Formula SAE Motorsport Team uses Abaqus to Cross Finish Line

Published on February 28, 2017
What is Formula SAE? Formula SAE is an international competition put on by the Society of Autom...

Excavator Simulation Workflow – Q&A

Excavator Simulation Workflow – Q&A

Published on February 23, 2017
Simulations have become more of an integral part of the product design and development process....

Designing and Calibrating Materials for Additive Manufacturing – Part 2

Designing and Calibrating Materials for Additive Manufacturing – Part 2

Published on February 21, 2017
In Part 1 of this blog post, I explored the procedure to design materials for purpose—from the ...